-
H3C switch fiber optic port not working
H3C recommends disabling STP on the port, or configuring the port as an edge port if the port is connected to a terminal device. If the issue persists, contact H3C Support. This document provides information about troubleshooting common software and hardware issues with the switches. To prevent a failure from causing loss of configuration, save the configuration each time you finish configuring. Copyright © 2022 Intelbras S. A, any trademarks that may be mentioned in this document are the property. Unexpected switch reboot Symptom The switch reboots unexpectedly when it is operating. Figure 1 Schematic Diagram of Optical Module Connected to Switch 1. It covers the different operational states of Combo ports, including electrical port, optical port, and auto-negotiation modes.
[PDF Version]
-
Installation of H3C 10 Gigabit Optical Module
H3C Transceiver Modules and Network Cables Installation Guide describes transceiver module and cable views and guides you through the installation of transceiver modules, including installation and removal procedures and installation verification. All these transceiver modules and network cables are hot swappable. Different types of optical modules have different performance parameters such as speed. subject to change without notice. All contents in this document, including statements, information, and recommendations, are believed to be accurate, but they are presented without warran y of any kind, express or implied. com Document version: 6W103-20240529. This preface includes the following topics about.
[PDF Version]